DESIGN AND FABRICATION OF PNEUMATIC BEARING PULLER, PRESS, SHEET BEND AND REMOVER
A “pneumatic operated bearing puller & press, sheet bend and remover” is a device which enables to operate it alone and removes the bearing from puller without puller setup from supporting device. So special skill is needed to operate or remove from. It can widely used. It is easy to fit on the bearing and removing and refitting. It is need not necessary of work place for setting the puller. This can be effectively used for removing. In this we are change the tool of sheet bend and removing tool for the purpose of sheet bending and removing operation in the same machine.
Also see: Hydraulic bearing Puller- Mechanical Project report Download
In this project we are using the pneumatic as pressing equipment; this will be useful in many applications. Like bending the metal sheets, bearing fixing and removing etc…
The compressed air from the compressor is used as the force medium for this operation. There are pneumatic double acting cylinders solenoid valves, flow control valve and the timer unit is used. The arm from the compressor enters to the flow control valve. The controlled air from the flow control valve enters to the solenoid valve. The function of solenoid valves all of air correct time interval. The 5/2 solenoid valve is used. In one position air enters to the cylinder and pushes the piston so that the operation stroke is obtained. The next position air enters to the other side of cylinder and pusses the piston return back, so that the releasing stroke is obtained. The speed of the operation and releasing stroke is varied by the timer control unit circuit.
- The pneumatic is more efficient in the technical field.
- Quick response is achieved
- Simple in construction
- Easy maintenance and repair
- Cost of unit is very less
- No fire hazard problem due to overloading
- Continuous operation is possible without stopping
- High torque can not be obtained
- Load carrying capacity is low
- This machine is very useful for small scale industries
- These machines used to removing and refitting the bearing from the shaft, and sheet bend and remove.
- All industrial application
DRAWING FOR PNEUMATIC BEARING PULLER, PRESS, SHEET BEND AND REMOVER
More Resources /articles
Thermal Engineering Projects List - Abstract , Report
Lathe Machine Projects List , Abstracts
Refrigeration and Air conditioning Projects
New Mechanical Projects 2020 ( All Projects Post Index List )
Pressure Vessels - Parts, Design, Application, Types, Material, Diagram
Introduction to Pressure Vessels Vessels, tanks, and pipelines that carry, store, or receive fluids are called pressure vessels. A pressure vessel is defined as a container with a pressure...
Knuckle Joint - Parts, Diagram, Design Calcuation, Applications
Knuckle Joint A knuckle joint is used to connect two rods which are under the action of tensile loads. However, if the joint is guided, the rods may support a compressive load. A knuckle joint...
One thought on “DESIGN AND FABRICATION OF PNEUMATIC BEARING PULLER, PRESS, SHEET BEND AND REMOVER”
Hello, This is ragu I need a frame calculation for the above project (pneumatic bearing pusher and puller)