GATE 2018 Online Mock Test For Mechanical Students
Graduate Aptitude Test in Engineering (GATE) is an examination conducted jointly by the Indian Institute of Science (IISc), Bangalore and the seven Indian Institutes of Technology (at Bombay, Delhi, Guwahati, Kanpur, Kharagpur, Madras and Roorkee) on behalf of the
National Coordination Board (NCB)-GATE, Department of Higher Education, Ministry of Human Resource Development (MHRD), Government of India.Gate 2018 Mock test will help students to understand exact process of GATE examination.
Qualifying in GATE is a mandatory requirement for seeking admission and/or financial assistance to:
(i) Master’s programs and direct Doctoral programs in Engineering/Technology/Architecture and
(ii) Doctoral programs in relevant branches of Science, in the institutions supported by the MHRD and other Government agencies. Even in some colleges and institutions, which admit students without MHRD scholarship/assistantship, the GATE qualification is mandatory. Further, many Public Sector Undertakings (PSUs) have been using the GATE score in their recruitment process.
GATE Mock Test 2018 –
IIT Guwahati has released the GATE 2018 Mock Test for all the aspirants on November 23, 2017. Candidates who will be preparing for GATE 2018 examination will be able to attempt the mock test for preparation purposes. By using the GATE mock test 2018, the candidates will be able to check the examination pattern and division of subjects while also experiencing the test in an environment similar to the examination. The GATE 2018 mock test is available online for all papers. Time management can also be honed by the candidates by using the GATE mock test 2018. Candidates will have to choose their respective GATE papers while attempting the mock test of GATE 2018. A total of 180 minutes will be provided to the candidates for solving the mock test. Read the full article to know the process and information about GATE mock test 2018.
Features of GATE Mock Test 2018
The candidates can check the main features of GATE 2018 mock test from the points given below:
The total duration of GATE mock test 2018 will be 180 minutes.
There will be 10 questions from General Aptitude and 55 questions from the repective paper for the engineering disciplines
There will be no scores allotted to the candidates after the mock test is over as the test is only for practice purpose.
The candidates will be able to use the given virtual calculator for calculations during the mock test, similar to the real examination.
By attempting the mock test, the candidates will be able to understand the exam pattern of GATE 2018 better.
All of the questions asked in the mock test will be from the previous year examination and therefore the candidates will be able to prepare well for the upcoming GATE 2018 exam.
Official Mock Test 2018 For Mechanical Students:
- Official Link For Gate 2018 Online Mechanical Mock test
- Official Link For Gate 2017 Online Mechanical Mock test
Introduction to Pressure Vessels Vessels, tanks, and pipelines that carry, store, or receive fluids are called pressure vessels. A pressure vessel is defined as a container with a pressure...
Knuckle Joint A knuckle joint is used to connect two rods which are under the action of tensile loads. However, if the joint is guided, the rods may support a compressive load. A knuckle joint...