Automatic Pneumatic Glass hole Drilling Machine-Mechanical Project
In small-scale industries and automobile maintenance shops, there are frequent needs of, drilling, boring, reaming machine. Huge and complicated designed parts cannot be machined in ordinary machine. Further for every operation separate machine is required. The increases the initial cost required, large area requirements and large number of machine are required.
In a single machine all the above specified operation can be carried out, i.e., after glass drilling,., after ordinary drillbit can be attached, and the operation can be performed. By the application of pneumatics, the pneumatic cylinder with piston which is operated by an air compressor will give the successive action to operate this machine. By this we can achieve our industrial requirements.pneumatic gun coupled with pneumatic cylinder.This machine very much useful to glasshole making machine.
The main objective of our project is to perform various machining operations using “Auto Feed Mechanism” in drilling machine with the help of pneumatic sources.
For developing industry the operation performed and the parts or components produced should have it minimum possible production cost, then only industry runs profitably.
In small-scale industry and automobile maintenance shops, there are frequent needs of , drilling, boring and reaming . Further for every operation separate machine is required. This increases the initial cost required, large area requirements and large number of machines is required. In our project the above complicated are rectified.
The compressed air from the compressor is used as the force medium for this operation. There are one pneumatic double acting cylinder used. The air from the compressor enters to the flow control valve.
The speed of one way of air enters to the pneumatic cylinder unit. Inside the cylinder having piston arrangement .This arrangement fixing for top of the Stand.
The other way of air enters to the solenoid valve. The function of solenoid valves all of air correct time interval. One-way of air enters to the cylinder 1 due to pressure different work piece is drilled . The other way of air enters to the cylinder due to pressure difference by means of drilling head is go to old position .solenoid valve is actuated which use of solenoid valve .pneumatic gun coupled with pneumatic cylinder ,solenoid valve controlled for timing control unit.This machine diamond drill bit used.
- It is used in glass house works.
- It is used for drilling rear view glass in house.
- Compact and portable, so easy to transfer and shift.
- Accuracy up to .01mm is obtained.
- Simple in construction
- Less power consumption.
- Machining time is less
- Maintenance cost is less.
- Weightless Mechanism.
- Only small pieces can be machined.
- Drilling can be done only for the glasses above 6 mm.
- Skilled labour is required
Pressure Vessels - Parts, Design, Application, Types, Material, Diagram
Introduction to Pressure Vessels Vessels, tanks, and pipelines that carry, store, or receive fluids are called pressure vessels. A pressure vessel is defined as a container with a pressure...
Knuckle Joint - Parts, Diagram, Design Calcuation, Applications
Knuckle Joint A knuckle joint is used to connect two rods which are under the action of tensile loads. However, if the joint is guided, the rods may support a compressive load. A knuckle joint...