Design and Fabrication Of Rotary Drum Filter Mechanical project
The most common type of continuous vacuum filter is the rotary drum filter in which liquor is sucked through a moving septum to deposit a cake of solids. The cake is moved out of the filtering zone, washed, sucked dry and dislodged from the septum.
It is consisting on a sheet metal drum. The diameter of drum ranges from 1 to 10 feet. This drum is carried on moving system. A vacuum system is also attached, so that, during filtration whole drum work under vacuum. The surface of the drum is the divided into different section by stripes.
i- Cake formation zone
ii- Washing zone
iii- Drying zone
iv- Cake removal zone
These steps are parallel to the axis of drum and welded to the shell. Filter medium is hold by metal strips on drum and covered by filter cloth.
In each section there are many pipes which open inside the cover plates. The side cover plate. There is also a stationary valve plate through which connection are made to the filtrate receiver. For compressed air and wash water connection vale are also given.
After washing, to remove the cake “Doctor knife” is provided. Doctor knife remove only the cake of from septum and does not damage the pre-coated layer of filter aid.
Working of Rotary Drum Filter :
Before filtration rotary drum filter is dip in tank of filter aid for pre-coating purpose. Commonly is pre-coated up 3” to 5” by diatomaceous earth, perlite or purified wood cellulose. After that drum is rotated in slurry tank at a speed of 1 to 2 rpm. 1/3 of drum is dip in slurry tank, vacuum is applied through a valve and filtration is started.
A layer solid builds in the form of cake on the surface of panel (filter cloth) in cake formation zone and filtrate pass through pipes and goes to vacuum receiver and collected in tank.
As, the panel leave the cake formation zone it enters to washing zone and in which water is sprayed on cake to extract all filtrate from cake and it sent to wash vacuum receiver. And panel enters to drying zone. In this section high vacuum is applied and all filtrate is sucked and cake is obtained in completely dried form.
Now this panel is moved to cake removal zone in which doctor knife remove dried cake from filter cloth without damaging the filter cloth. After that this panel again enter to cake formation zone for continuous filtration and cycle is repeated.
Applications Of Rotary Drum Filters :
- These filter are developed to overcome large problem of filter press and leaf filter. It is very versatile filter.
- It is used generally for those operation in which the volume is very large, where process is continuous and where is labor cost must be
kept downs. It is used where colloidal particles.
- It is used for production of wallboard from gypsum.
Limitations Of Rotary Drum Filters :
- It cannot be used for mixture of colloidal and coarse particles.
- It must be used continuously.
Pressure Vessels - Parts, Design, Application, Types, Material, Diagram
Introduction to Pressure Vessels Vessels, tanks, and pipelines that carry, store, or receive fluids are called pressure vessels. A pressure vessel is defined as a container with a pressure...
Knuckle Joint - Parts, Diagram, Design Calcuation, Applications
Knuckle Joint A knuckle joint is used to connect two rods which are under the action of tensile loads. However, if the joint is guided, the rods may support a compressive load. A knuckle joint...