SENSOR OPERATED ELECTROMAGNETIC CLUTCH AND GEAR CHANGING, BRAKING SYSTEM – Buy Project
The objective of this project is to design the Sensor operated Electromagnetic clutch and braking system using Object sensor for Automobiles. This project is mainly used in Vehicles either two or four wheelers. In this project is used in real time we can avoid so many accidents.
This project is designed by following blocks
• Object sensor
• Electromagnetic clutch
• Solenoid valve
• Pneumatic cylinder
• Control unit
BLOCK DIAGRAM FOR SENSOR OPERATED ELECTROMAGNETIC CLUTCH AND BRAKING SYSTEM
The object sensor senses the object and gives corresponding signals. These electrical signals are very small mill voltage signal, so it is given to amplifier circuit. The amplifier circuit is constructed with operational amplifier which acts as power amplifier. Then the amplifier signal is given to signal conditioning unit which also constructed with operational amplifier. In this circuit operational amplifier act as comparator and generate the square pulse given to microcontroller.
It will work according to our object already we have programmed. According to the object sensor value, the microcontroller activates the driver circuit as per mentioned in the program. Then it makes the solenoid valve to pass the air from the compressor to the pneumatic cylinder to apply the brake of the wheel which runs by the separate motor. The driver circuit is constructed with transistor which acts as switch to control the relay. The relay output is directly connected to the electromagnetic core which is attached in the Clutch assembly which gets activated immediately after applying the brake. This project is easily to apply in automobiles to avoid accidents.
- The relevant advantages are
- Can use all type of vehicles
- Low cost
- Low power consumption
• Can be used in all vehicles to avoid major accidents
More Resources /articles
Automobile Engineering Projects List - Abstract , Report
New Mechanical Projects 2020 ( All Projects Post Index List )
Pressure Vessels - Parts, Design, Application, Types, Material, Diagram
Introduction to Pressure Vessels Vessels, tanks, and pipelines that carry, store, or receive fluids are called pressure vessels. A pressure vessel is defined as a container with a pressure...
Knuckle Joint - Parts, Diagram, Design Calcuation, Applications
Knuckle Joint A knuckle joint is used to connect two rods which are under the action of tensile loads. However, if the joint is guided, the rods may support a compressive load. A knuckle joint...
2 thoughts on “Sensor Operated Electromagnetic Clutch And Gear Changing, Braking System”
Bro cost estimation ?
can u make it one our project is electromagnetic clutch , if u r intrested plz contact 8919503095